TextUsSm

 

 
WeSpeakJacuzzi1
 
 
Installation Help

OEM Downloads

T7StopsideT8s Topside T7s AND T8s CURRENT Topside Manual
Install Manual 2021 C5 Control Installation Install Manual
T7topside T-7  Small Topside Manual
(DISCONTINUED)
See Here
T8Xtopside C-5 TX8 Topside Manual
(DISCONTINUED)
See Here
T8oldTOPSIDE C-5 Large Topside Manual
(DISCONTINUED)
See Here



T7s Topside T7s
5" wide and 2.5" tall

Requires 1.75" hole
               T8s Topside T8s
6 3/8" wide and 3 3/8" tall

Requires 3 2 1/4" holes


      Display and Error Codes and their Meaning

Spa is filtering. Not an error.

Spa is Heating. Not an error.

Freeze Mode: Below 45O . Low speed will come on and continue until spa reaches 48. No other function will work. Not an error.

Water is over 113O. To reset turn spa off briefly and power up.

Heater sensor is heating above 116O Low speed pump will come on to cool down spa. Once below 103 you can hold temp sensor down 10 minutes to reset.

Temp sensor malfunction (sensor in spa wall)  Check connection is secure. Replace if is.

High Limit/OH sensor malfunction (sensor attached to heater) Check connection is secure. Replace if is.

Not enough water flow. Check filters and pump. If still occurs with adequate water flow, replace pressure switch. If no water flow replace pump/motor. If error stops when filters are removed, replace filters.

 

Warning: Although these systems are designed for ease of installation, not everyone is qualified to install.

 

 
Copyright 2021 Clear Creek Spas
All Rights Reserved