Replacement Topsides

Below find a complete inventory of topsides used by Jacuzzi that we carry.
To limit to your generation or model name use fitler feature on right or bottom of the page.

Topsides typically do not interfere with spa operation. If you lose the ability to push one button and do not get the action in should call for, you normally have to replace the whole topside. There are not repair parts for the topside. If the complete topside fails all at once, usually you look at the board to be at fault in the main control box.

These units are complete and self contained and water resistant.

All the shown topside above are held in place by double sticky tape. To remove you cover a wide blade screwdriver, slide in between topside and spa shell (you covered the blade to protect the finish). Twist the screwdriver and the topside normally pops off. Clean and reverse to add new topside.

If after you turn the main power on you don't see anything on the topside readout and the spa doesn't come on, then likely its a board issue. If there is nothing on the topside BUT the spa does come on, then good chance it is the topside.