Jacuzzi 1983-1993 Models Jacuzzi 1994-2002 Models Jacuzzi 2002-Present Models Gatsby Spas Spa Siding Retro Kits
NEW 303-390-8959 Phone Texting 

Search Clear Creek Spas

Replace Heater Element

See typical failed heater element by rust on left nut.

Remove nuts holding element in place

Clean area. Make sure you do not bend area around hole.

When installing new element, make sure the rubber o-rings are as shown. They must be on the inside of the housing with the new nut tightening them and making the seal.

New element installed.

Suggestions: a. Make sure the element is basically centered in the housing when tightening the 2 nuts. b. Sometimes a clip or two on the element can be removed to allow ease of installing new element in housing.



Manufacturers recommend you use a wrench above and below when tightening the element nut to the board. Failure can twist or bend the element post and damage it.


Copyright 2020  Clear Creek Spas
All Rights Reserved